AStrutTie – Design Strut and Tie Model Step (4) – Modeling and Analysis of Truss Model

Modeling and Analysis of Truss Model

After the finite element analyses for the stress trajectories and evolutionary structural optimization, Truss Model need to be selected. The boundary elements of truss model are generated based on the outer boundary of concrete member by clicking DESIGN-Create Truss From Boundary (Dialog). In the dialog, the distance between the boundary of concrete member and the boundary elements of truss model is set.

4j1

The boundary elements of truss model can be edited depending on designers’ decision. To make the editing easier, the functions Guide Line and Grid are provided. The orthogonal guide lines are available by clicking F8 key. An example to generate the boundary elements of truss model by clicking Dynamic Guide Line is shown below.

4j2

Based on the guidelines and by using Add Elements, additional elements of truss model are generated as shown below.

4j3

The unnecessary elements of truss model are deleted by using Del Key or Delete functions after selecting the elements.

4j4

The external loads assigned in the Beginning Mode are converted to the loads acting on the generated truss model by clicking ASSIGN-Boundary Load To Truss Load. The loads on truss model can be input again by designers’ decision.

4j5

4j6

After selecting the nodes on which restraints must be imposed, the boundary conditions are setup by clicking ASSIGN-Restraints. The structural analysis on the truss model is conducted by clicking ANALYSIS-Run Analysis. After the analysis, the results including element forces are shown on the truss model.

4j7

The compressive principal stress flows or the optimization results obtained earlier can be overlapped on the truss model by activating VIEW-View Options, as shown below.

4j8

AStrutTie – Design Strut and Tie Model Step (1) – Modeling of Structure

AStrutTie – Design Strut and Tie Model Step (2) – Application of Load

AStrutTie – Design Strut and Tie Model Step (3) – Structural Analysis for ESO & Stress Flow

AStrutTie – Design Strut and Tie Model Step (4) – Modeling and Analysis of Truss Model

AStrutTie – Design Strut and Tie Model Step (5) – Analysis Results and Structural Design Report

Be the first to comment

Leave a Reply